[. . . ] 3) und dann 4 DE - 2 Please read and comply with these instructions prior to the initial operation of your appliance. [. . . ] Select correct memory block (see section "Select memory block"). Channels that have already been programmed in the coins channel can be reprogrammed at any point of time. To cancel the procedure, first set the DIL switch of the corresponding coin channel (here S2. To cancel the procedure, first set the DIL switch of the corresponding coin channel (here S2. Possible reasons for failure – Excess of already programmed coins – Measurement error while programming – Programming has been cancelled – DIL switch could not be operated in the correct sequence – DIL switch has not locked in correctly at the time of pressing Release the coin channel for the teachin by setting the respective DIL switch (B0: S2. Note You can preferably select the coin channel with the desired value "C" (see type plate). Insert at least 10 coins of the new coin type / value (with various degree of wear). Saving the coin channel You now have the option of saving the measured values generated after inserting the coins with a normal (A) or wider (B) acceptance range. [. . . ] SV - 1 21 I Teach-modus kan valfri mynttyp med diameter från 15 mm till 31, 5 mm och mynttjocklek på 1, 5 mm till 3, 3 mm programmeras. [. . . ]